| Document Description | Last Updated | Filename | |
| Testing the AQ251 circuit board. | 6/20/2008 | 2000 AQ251 Test.pdf |
|
| Troubleshooting the open position limit switch on a pull to open gate. | 6/20/2008 | 2000 BLU Limit Troubleshooting.pdf |
|
| Instructions for mounting the operator arm to a column. | 6/20/2008 | 2000 Column Mounting Instructions.pdf |
|
| Wiring the power cable to the limit switches in the back of the operator arm. | 6/20/2008 | 2000 Limit Switch Wiring.pdf |
|
| Troubleshooting low battery voltage or a dead cell in the battery. | 6/20/2008 | 2000 Low Voltage.pdf |
|
| Instructions for checking the limit switch for the closed position on a pull to open gate. | 6/20/2008 | 2000 ORG Limit Troubleshooting.pdf |
|
| Instructions for programming a pre-ETL circuit board with five programming buttons. | 6/20/2008 | 2000 Pre-ETL Programming Instructions.pdf |
|
| Instructions for setting the closed position limit on a pull to open gate. | 6/20/2008 | 2000 Set Closed Limit.pdf |
|
| Instructions for adjusting the stroke on the operator arm. | 6/20/2008 | 2000 Stroke Adjustment.pdf |
|
| How to wire a variable resistor to the red motor lead in order to slow the motor down. | 6/20/2008 | 2000 Variable Resistor Wiring.pdf |
|
| Show Page: | 1 | (Total Records: 10) | | Records Per Page: | |
|